Murphy PowerView PV-101 Manual do Utilizador descarregar pdf (Página 25)

00-02-0605 - 21 - Rev 09-10-08

Auxiliary Gage Fault

Murphy’s PVA Gages can be attached to the PowerView. If

an auxiliary gage should fail, the 1-up or 4-up display will be

replaced with the fault message “GAGE NOT

RESPONDING”.

NOTE: The fault can only be cleared by correcting the

cause of the fault condition.

Active Fault Codes

When the PowerView receives a fault code from an engine,

the 1-up or 4-up display will be replaced with the active fault

codes message.

Derate / Shutdown Codes

When the PowerView receives a severe fault code from an

engine control unit the 1-up or 4-up display will be replaced

with the SHUTDOWN message.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Sem comentários

Murphy PowerView PV-101 Manual do Utilizador Página 25